Two-Piece

REMOVAL
1. With the vehicle in neutral, raise and support the vehicle.

WARNING: THE ELECTRICAL POWER TO THE AIR SUSPENSION SYSTEM MUST BE SHUT OFF PRIOR TO HOISTING, JACKING OR TOWING AN AIR SUSPENSION VEHICLE. THIS CAN BE ACCOMPLISHED BY TURNING OFF THE AIR SUSPENSION SWITCH LOCATED IN THE REAR JACK STORAGE AREA. FAILURE TO DO SO CAN RESULT IN UNEXPECTED INFLATION OR DEFLATION OF THE AIR SPRINGS WHICH CAN RESULT IN SHIFTING OF THE VEHICLE DURING THESE OPERATIONS.





2. Index the driveshaft to driveshaft rear axle companion flange.





3. Remove the four rear driveshaft bolts, and disconnect the rear driveshaft.





4. Remove the rear driveshaft.
1 Remove the two driveshaft center bearing support bolts.
2 Lower the rear driveshaft, and slide the driveshaft slip yoke rearward off the transmission output shaft and remove the rear driveshaft.
^ Plug the extension housing to prevent fluid loss.

INSTALLATION








1. Follow the removal procedure in reverse order.