Transmission Position Sensor/Switch: Service and Repair

Special Tools:

1. Raise and support vehicle.





2. Disconnect the manual lever shift control cable.
3. Disconnect the digital TR electrical connector.





4. CAUTION: Discard outer manual control lever shaft nut. Do not reuse. The old nut will not retain torque specification.

Remove the manual control lever.
1 Remove the nut.
2 Remove the lever.
5. Loosen the digital TR sensor bolts.





6. NOTE: Manual shift lever must be in the neutral position.

Use digital transmission range TR Sensor Alignment Tool, to align the digital TR sensor slots. The tool is designed to fit snug.





7. Tighten the bolts.





8. Install the manual control lever.
1 Position the manual control lever.
2 Install a new manual lever shaft outer nut.





9. With the manual lever in overdrive connect the shift lever control cable.
10. Install the digital TR sensor electrical connector.
11. Lower the vehicle.