Engine General Specifications
1 of 7
2 of 7
3 of 7
4 of 7
5 of 7
6 of 7
7 of 7
Footnotes:
a Newly installed - Refers to the condition of the NEW drive belt before the engine has made no more than one rotation and before the belt has had a chance to stretch or seat into the pulley grooves.
b Head Gasket Surface - WT = 10.0/2.5. Head Gasket Surface Finish - RZU - 13.5 microns. Filter cut off at 0.08 mm TPI @ 3.5 microns below the peak 63% min. cut off at 0.8 mm, 0 ref = 2V.
c Time required for the plunger to leak down 1.6 mm of travel with 222 N of force and leak-down fluid in tappet.
d The pin bore and crank bearing bore must be parallel and in the same vertical plane with the specified total difference when measured at the ends of a 203 mm bar, 105.5 mm on each side of the rod centerline.