Power Seat Switch: Service and Repair

SEAT CONTROL SWITCH

Removal

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- To reduce the risk of personal injury, do not use any memory saver devices.
- The belt and buckle assembly pretensioner is a pyrotechnic device. Never probe the connectors on the belt and buckle assembly pretensioner. Doing so can result in belt and buckle assembly pretensioner or air bag deployment and can result in personal injury.


NOTE:
- If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the SRS. Service and Repair







2. Remove the screw from behind the seat back latch handle.







3. Remove the front seat back latch lower cover screw from the front of the seat.







4. Remove the front seat back latch cover screw from the underside of the seat.







5. Disconnect the seat control switch electrical connector.







6. Remove the seat control switch.
1 Pull the front seat back latch cover away from the seat.
2 Pull the seat control switch electrical connector through the seat cushion.
3 Remove the screws.
4 Remove the seat control switch.

Installation







1.
1 Install the seat control switch to the front seat back latch lower cover.
2 Install the screws.
3 Route the front seat back latch lower cover to the seat.
4 Position the front seat back latch lower cover to the seat.







2. Connect the seat control switch electrical connector.







3. Install the front seat back latch cover screw to the underside of the seat.







4. Install the front seat back latch lower cover screw to the front of the seat.







5. Install the screw behind the seat back latch handle.
6. Repower the SRS. Service and Repair