Cylinder Head Assembly: Specifications

Engine General Specifications

Tightening Specifications

CAUTION: Install new bolts during installation. The bolts are tighten-to-yield designed and cannot be reused.


The LH is shown; the RH is similar.

Note: Be sure to tighten the bolts in three stages.





Tighten the LH bolts in the sequence shown.
- Stage 1: Tighten to 37 - 43 Nm (27 - 32 ft. lbs.).
- Stage 2: Tighten an additional 85 - 95 degrees.
- Stage 3: Tighten an additional 85 - 95 degrees.