Windows and Glass: Description and Operation

FEATURES AND OPERATION
If equipped with power windows, the window control switch:
^ will operate the power windows only when the ignition switch is in the RUN or ACC position.

NOTE: The accessory delay feature will allow power window operation up to 10 minutes after the ignition is off or until a door is opened.

^ is located on each front door trim panel and Crew Cab and Excursion rear door trim panel.
^ may be used to raise or lower the driver side, passenger side and rear windows from the LF control on the driver side, or the passenger window from the passenger switch.
^ includes a one-touch down feature for the driver door window.
^ can partially lower the driver side window when the LF window control switch is depressed halfway (first detent).
^ will completely lower the driver side window when the LF window control switch is fully depressed and then released second detent).

MODES OF OPERATION
There are two modes of operation for the power window system.

Manual Mode
When the LH window control switch is pressed to the first down position, the window will move down until one of the following conditions are met:
^ The LH window control switch is no longer in the first down position.
^ The LH window control switch is pushed to the One-Touch Down (OTD) Position, causing the windows to enter auto mode.

Auto Mode
Auto mode provides the One-touch Down (OTD) feature. The OTD feature is activated when the LR window control switch, for the LH window, is pressed to the second down position.

Auto mode will be terminated when any of the following conditions are met:
^ The LH window control switch is pushed to the up position.
^ The LH window control switch is released (OFF position) and then moved to the down position (first detent) or OTD position second detent).

NOTE: Delayed accessory feature must be active.

One-Touch Down Relay
The One-touch-down (OTD) feature is controlled by the one-touch down relay. The relay is activated by the window control switch.