Compressor/Pump: Service and Repair

Removal

WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing of an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the rear jack storage area. Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.

1. Raise and support the vehicle.
2. Remove the spare tire.





3. Disconnect the air compressor electrical connector.





4. Disconnect the air line from the drier.
1 Compress the quick connect locking ring and pull out the air line.
2 Remove the air line from the drier.





5. Remove the air compressor assembly from the vehicle.
1 Remove the air compressor bolts.
2 Remove the air compressor assembly.

Installation





1. Note: When installing the air lines make sure the white air line is fully inserted into the fitting for correct installation.

To install, reverse the removal procedure.