Output Shaft Ring Gear and Hub Shaft Assembly

Disassembly

1. Inspect the output shaft ring gear, output shaft hub, needle bearing (10B), and needle bearing race (10A) assembly for damage. If service is required use the following procedure.





2. Remove the No. 10B needle bearing.





3. Remove the No. 10A needle bearing race assembly.





4. Remove the output shaft hub from the output shaft ring gear.
1. Remove the retaining ring.
2. Remove the output shaft hub.

Assembly





1. Install the output shaft hub onto the output shaft ring gear.
1. Install the output shaft hub.
2. Install the retaining ring.





2. Install the No. 10A needle bearing race assembly.
- Snap the needle bearing race assembly onto the output shaft hub.





3. Note: Use petroleum jelly to hold needle bearing to.

Install the No. 10B needle bearing onto output shaft ring gear and output shaft hub.