Initial Inspection and Diagnostic Overview

NOTE: The Passive Anti-Theft System (PATS) module must be reconfigured upon replacement of the instrument cluster. Refer to the scan tool help screen on the configuration card to program.

1. Verify the customer concern by duplicating the condition.







VISUAL INSPECTION CHART

2. Visually inspect for obvious signs of mechanical and electrical damage.
3. If the concern remains after the inspection, connect the scan tool to the Data Link Connector (DLC) located beneath the instrument panel and select the vehicle to be tested from the scan tool menu. If the scan tool does not communicate with the vehicle:
^ check that the program card is properly installed.
^ check the connections to the vehicle.
^ check the ignition switch position.

4. If scan tool still does not communicate with the vehicle, refer to the scan tool manual.
5. Perform the DATA LINK DIAGNOSTIC TEST. Pinpoint Test PC (Precheck)
If scan tool responds with:
^ CKT914, CKT9I5 or CKT70 = ALL ECUS NO RESP/NOT EQUIP, refer to Module Communication Network (Information Bus).
^ NO RESP/NOT EQUIP for instrument cluster module, go to Pinpoint Test A. Test A: No Communication With Instrument Cluster Module
^ SYSTEM PASSED, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs and perform self-test diagnostics for the instrument cluster module.

6. If the DTCs retrieved are related to the concern, go to Instrument Cluster Diagnostic Trouble Code (DTC) Index to continue diagnostics. Diagnostic Trouble Code Tests and Associated Procedures
7. If no DTCs related to the concern are retrieved, proceed to Symptom Chart to continue diagnostics. Symptom Related Diagnostic Procedures