High Pressure Oil Pump Drive Gear

Dial Indicator With Bracketry:

SPECIAL TOOL(S)

REMOVAL
1. Remove the high-pressure oil pump reservoir.
2. Remove the high-pressure oil pump.
3. Remove the driver gear from the crankcase front cover.
4. Remove all gasket residue from the mating surfaces.

INSTALLATION
1. Position the drive gear into the crankcase front cover.
2. Install the high-pressure oil pump.







3. Position the drive gear onto the oil pump, and install the bolt and washer.

CAUTION: Make sure that the drive gear is fully seated on the high-pressure oil pump before Installing the bolt and washer. Otherwise the drive gear may not seat properly, causing binding or slippage resulting in a no oil flow condition.







4. Position the Dial Indicator with Bracketry onto the oil pump drive gear, and check the drive gear backlash. If not within specification, replace the drive gear.
5. Install the high-pressure oil pump reservoir.