QT: Powertrain Control Module (PCM) Quick Test

QT: Step 1: PCM QUICK TEST

QT1 PERFORM PCM QUICK TEST

Note: If the vehicle was brought in with an emission compliance failure symptom, please refer to: Pinpoint Test EM Tests EM: Emissions Compliance

- Complete preliminary checks looking for obvious concerns that may relate to the symptom. Check items such as those listed:
- Related electrical connectors or fuses
- Vacuum lines (leaks, routing )
- Air intake system (leaks, restrictions)
- Fuel quality (octane, contamination winter/summer blend)
- Cooling system (engine operating at proper temperature)
- Access any related OASIS or TSB information (if available).
- Complete PCM Quick Test to access any DTCs. Note any Key On Engine Off, Key On Engine Running (if engine runs) and Continuous Memory (MIL and non-MIL) DTCs.

Note: If unable to access DTCs, or any scan tool communication concern exist, refer to Pinpoint Test QA Standard Models (Non Bi-Fuel) (Base Gasoline) for additional information on retrieving MIL and non-MIL DTCs, refer to Diagnostic Methods Diagnostic Methods Overview (Continuous Memory Self-Test).

Were any DTC present?






QT2 ENGINE RUNS ROUGH AT IDLE WITH KEY ON ENGINE RUNNING OR CONTINUOUS MEMORY DTC(S): CHECK INJECTOR FAULT (INJxF) PID(S)

Note: An injector circuit could result in unrelated DTC(s) being received from the PCM.

- Key on, engine off.
- Access the INJxF PIDs (the "x" indicates the injector number). There will be one INJxF PID for each engine cylinder.

Does any of the INJxF PIDs indicate "Yes"?