Installation

Special Tools:

Special Tool(s)

1. Using the High Lift Transmission Jack, raise and position the transmission to the engine and clutch.





2. Install the six bolts.





3. Install the LH crossmember bolts.





4. Install the RH crossmember nuts.





5. Install the transmission mount nuts.








6. Install the engine plate bolts.
7. Remove the High Lift Transmission Jack.





8. Connect the transmission cooler tubes.





9. Install the clutch slave cylinder.
^ Rotate the clutch slave cylinder clockwise 45 degrees to lock in position.

10. Install the starter.
11. Install the transfer case, if equipped.
12. Connect the driveshaft.
13. Install any Power Take-Off (PTO) equipment, if equipped.





14. Connect the reverse lamp switch electrical connector.





15. Connect the wiring harness to the transmission.
16. Refill the transmission to specification.
^ Refill the transmission with MERCON.

17. Lower the vehicle.





18. CAUTION: Do not use a silicone sealing compound.

NOTE: Do not wait longer than ten minutes to tighten the six bolts due to the rapid cure time of the sealant.

Install the lower gearshift lever and shift housing assembly.
^ Apply gasket maker to the shift housing and the main case.





19. Install the lower shift lever boot.





20. Install the upper gearshift lever.





21. Install the screws.
22. Connect the battery ground cable.