Headlamp: Service and Repair

REMOVAL

WARNING: THE HALOGEN BULB CONTAINS GAS UNDER PRESSURE. THE BULB MAY SHATTER IF THE GLASS ENVELOPE IS SCRATCHED OR IF THE BULB IS DROPPED. HANDLE THE BULB CAREFULLY. GRASP THE BULB ONLY BY ITS BASE. AVOID TOUCHING THE GLASS ENVELOPE.

NOTE: The headlamp bulb should not be removed from the headlamp until just before a replacement bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the headlamps with the bulb removed from the headlamp.

1. Raise and support the hood.







2. Remove the headlamp assembly.
1 Raise the headlamp retainers by pushing rearward and pulling up.
2 Disconnect the headlamp electrical connector.
3 Remove the headlamp assembly.

NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.

INSTALLATION
1. To install, reverse the removal procedure.
^ If necessary, adjust the headlamps.

NOTE: Be sure the headlamp assembly is positioned correctly with the alignment pins inserted into the correct holes and onto the ribs of the reinforcement.