Transmission Position Sensor/Switch: Service and Repair

Special Tools:

Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.





3. Disconnect the shift cable.
1. Disconnect the shift cable from the manual control lever.
2. Disconnect the shift cable from the bracket.





4. Disconnect the digital transmission range (TR) sensor electrical connector.





5. Remove the manual control outer lever nut and manual control outer lever.





6. Remove the screws and the digital TR sensor.

Installation





1. Install the digital TR sensor.
1. Position the digital TR sensor.
2. Loosely install the screws.





2. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.

Note: The manual lever must he in the neutral position.

Using the special tool, align the digital TR sensor and tighten screws in an alternating sequence.





3. Install the manual control outer lever.
1. Install the manual control outer lever.
2. Install the manual control outer lever nut.





4. Connect the digital transmission range (TR) sensor electrical connector.





5. Connect the shift cable.
1. Connect the shift cable to the bracket.
2. Connect the shift cable to the manual control lever.
6. Verify that the shift cable is adjusted.
7. Lower the vehicle.
8. Connect the battery ground cable.