Independent Rear Suspension

Wheel Bearing

Removal And Installation
1. Remove the wheel knuckle.

2. CAUTION: Make sure that the press adapter outside diameter is slightly smaller than the hub outside diameter or damage to the knuckle will result.





Using a suitable press, remove the hub from the bearing.

- Discard the hub.

3. NOTE: The retainer ring is tapered and must be installed flat side down.





Remove the retainer ring.

- Discard the retainer ring.





4. Using a suitable press, remove the bearing from the wheel knuckle.

- Discard the bearing.

5. CAUTION: The hub and bearing cannot be reused after disassembly.

To install. reverse the removal Procedure.