Glass

REMOVAL

NOTE: Left-hand dual arm mirror with heat shown, non-heated and aero mirrors similar.

1. Position the exterior rear view mirror glass in the full down position.







2. Grasp the top and carefully pull the mirror glass away from the mirror housing.







3. Disconnect the electrical terminals (if equipped) and remove the exterior rear view mirror glass.

INSTALLATION







1. Remove the jack pins from the mirror glass back.







2. Remove the sealing boots.







3. Install the jack pins in the sealing boots.







4. Install the jack pins and sealing boots.
1 Install the jack pins in the mirror housing.
2 Install the sealing boots so the boot shoulder is under the mirror collar.







5. Loosely install the glass.
1 Connect the electrical wiring to the electrical terminals (if equipped).
2 Position the friction pins in the mirror housing.
3 Align the jack pin locating tabs to match with the mirror glass back.
6. Using a flat hand, press on the center of the mirror glass until seated on the center pivot of the mirror housing.
^ Press the mirror glass toward one of the jack pins until snapped in place.
^ Repeat for second jack pin.