Bar and Link - Super Duty F-450, F-550, Dana Axle

Bar and Link - Super Duty F-450, F-550, Dana Axle

Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. Install new parts with the same part number or an equivalent part if installation is necessary. Do not use an installation part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Raise and support the vehicle.






2. Remove the nuts from both lower ends of the stabilizer bar links and remove the washers.






3. Remove the nuts and washers from both upper ends of the stabilizer bar links and remove the links.






4. Remove the bolts from both stabilizer bar retainer-to-axle brackets and remove the stabilizer bar.
- Remove the stabilizer bar bushings if necessary.
5. To install, reverse the removal procedure.
- Install all new fasteners.