Ignition Cable: Service and Repair

"AllData Editors Note:

Customers have reported success using the following spark plug wire placement on the coil pack."

Remover, Spark Plug Wire:

SPECIAL TOOL(S)

REMOVAL

CAUTION: Do not pull on the spark plug wire as it may separate from the spark plug wire connector inside the spark plug wire boot.







1. Use the Spark Plug Wire Remover to grasp and twist the spark plug wire boot back and forth on the spark plug insulator to release the connector.







2. Disconnect the spark plug wire from the ignition coil by twisting while pulling upward.
3. Open the spark plug wire separators and remove the spark plug wire.

INSTALLATION
1. To install, reverse the removal procedure.
^ Use a small, clean tool to coat the entire interior surface of the boot with silicone brake caliper grease.

CAUTION: Correct installation of the spark plug wires is critical to vehicle operation. If one spark plug wire is not correctly installed on the spark plug or ignition coil, both spark plugs connected to that segment of the ignition coil may not fire under load.

NOTE: Wipe the spark plug wires with a clean, damp cloth prior to inspection.