Auxiliary Evaporator Outlet Line

REMOVAL

CAUTION: It may be necessary to cut the underbody auxiliary line(s) being serviced into sections to facilitate removal. Make sure to correctly identify the line(s) being serviced before carrying out any cutting of the line(s).

NOTE: Lay out the new lines in vehicle position to assist in the installation.

1. Discharge and recover the refrigerant. Refer to: Heating and Air Conditioning, Service and Repair, Refrigerant Discharging and Recovery Procedure, Refrigerant Discharging and Recovery Procedure

2. Remove the right-hand fender splash shield.
3. Remove the rear right-hand wheel.







4. At the rear of the vehicle, disconnect the evaporator outlet line spring lock coupling.







5. Remove the five line bracket retaining nuts.







6. Remove the five line brackets by inserting a screwdriver in the stud hole and twisting.

CAUTION: Pull the bracket off the stud before attempting to pry it off the lines to prevent component damage.







7. Disconnect the auxiliary evaporator outlet line fitting.
8. Remove and discard the auxiliary evaporator outlet line.

INSTALLATION







1. Install the rear auxiliary evaporator outlet line and connect the spring lock coupling to the auxiliary evaporator outlet line.

NOTE: Lubricate the O-ring seals with PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN-12-C) or equivalent meeting Ford specification WSH-M1C231-B.

2. Snap the rear auxiliary evaporator outlet line into the line brackets.







3. Install the front auxiliary evaporator outlet line through the wheel well and connect the evaporator outlet line.

NOTE: Lubricate the O-ring seals with PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN-12-C) or equivalent meeting Ford specification WSH-M1C231-B.

4. Snap the front auxiliary evaporator outlet line into the brackets.







5. Install the brackets over the studs and loosely install the nuts.







6. Connect the two auxiliary evaporator outlet lines.

CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.

NOTE: Lubricate the O-ring seals with PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN-12-C) or equivalent meeting Ford specification WSH-M1C231-B.







7. Tighten the five bracket nuts.

CAUTION: Overtightening of the nut will cause the stud to break away from the floor pan.

8. Install the right-hand fender splash shield.
9. Install the right-hand wheel.
10. Lower the vehicle.
11. Evacuate, leak test and charge the A/C system. Refer to: Heating and Air Conditioning, Service and Repair, Evacuating and Charging, Evacuation and Charging