Scan Tool Testing - Conventional Cluster - Instrument Cluster

NOTE: Following installation of the new instrument cluster, it is necessary to reset the PCM ID and carry out the PATS parameter reset procedure.

1. Connect battery (last step of the removal and installation procedure).
2. Carry out the PATS parameter reset procedure.
3. Disconnect the battery.
4. Wait three minutes to clear the PCM keep alive memory then reconnect the battery.
5. Position the first PATS key to run for three seconds. Within three seconds, remove and insert the second PATS key and position to run for three seconds. This will store both PATS keys and the PCM ID into the new instrument cluster module.