Transmitter

REMOTE TRANSMITTER PROGRAMMING

NOTE: All keyless entry remote transmitters are programmable and must be set at the same time.

1. Make sure that the anti-theft system is not armed or triggered.
2. Turn the ignition switch from OFF to RUN 8 times within 10 seconds, ending in RUN. If the central security module has successfully entered program mode, it will lock and then unlock all doors.
3. Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.
4. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to Diagnosis and Testing.
5. Turn the ignition switch to the OFF position, or wait up to 20 seconds after Step 2, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the central security module will lock and unlock all doors one last time to confirm.