Driver Seat
DRIVER SEATSeat Belt Bolt Bit:
SPECIAL TOOL(S)
REMOVAL
All vehicles
1. Position the driver seat rearward.
2. Remove the driver seat front track-to-floor bolts.
3. Move and tilt the front seats to their highest and most forward position.
Vehicles with power seats
4. Disconnect the battery ground cable.
5. Disconnect the power driver seat electrical connector.
All vehicles
6. Remove the safety belt buckle support bolt cover plug.
7. Using the special tool, remove the safety belt buckle support bolt.
8. Disconnect the safety belt warning indicator electrical connector.
9. Remove the driver seat rear bolt trim covers.
10. Remove the driver seat rear bolts.
11. CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result in damaged components.
Remove the driver seat from the vehicle.
INSTALLATION
All vehicles
1. Position the seat into the vehicle. Install all the seat track-to-floor bolts and hand-tighten them.
Vehicles with power seats
2. Connect the power seat electrical connector.
3. Connect the battery ground cable.
All vehicles
4. Position the seat rearward.
5. Tighten the seat front track-to-floor bolts in sequence shown.
1 Tighten the front inboard bolt.
2 Tighten the front outboard bolt.
6. Move and tilt the seat to its highest and most forward position.
7. Tighten the seat rear track-to-floor bolts in sequence shown.
1 Tighten the rear inboard bolt.
2 Tighten the rear outboard bolt.
8. Install the rear track bolt covers.
9. Connect the safety belt warning indicator electrical connector.
10. Using the special tool, install the safety belt buckle bolt.
11. Install the safety belt buckle support bolt cover.
12. Check the active restraint system for correct operation.