Steering Column Sensor Ring

Removal

CAUTION: The steering column must be in the locked position, or the lower end of the column wired in such a way that the steering column does not rotate, resulting in damage to the air bag sliding contact.

NOTE: Discard the upper intermediate shaft to steering column shaft bolt upon removal. Do not reuse; install a new bolt.





1. Remove the upper intermediate steering shaft to column shaft bolt.
1 Remove and discard the steering column shaft pinch bolt.
2 Slide the intermediate shaft yoke from the steering column.





2. Remove the steering wheel rotation sensor.
1 Disconnect the electrical connector.
2 Remove the screws.
3 Remove the steering wheel rotation sensor.





3. Remove the sensor ring.
1 Remove the steering column lower bearing spring.
2 Remove the sensor ring.

Installation
1. To install, reverse the removal procedure.





2. Install the steering wheel rotation sensor.
1 Position the steering wheel rotation sensor.
2 Install the screws.
3 Connect the electrical connector.





3. Use a new pinch bolt. Steering Column Shaft.

Removal

1. CAUTION: The steering column must be in the locked position, or the lower end of the steering column is to be secured or wired in such a way as to prevent the steering column from rotating, resulting in damage to the air bag sliding contact.

NOTE: Discard the upper intermediate shaft to steering column shaft bolt and the upper intermediate shaft to lower steering column shaft bolt upon removal. Do not reuse; install new bolts.





Remove the bolt securing the upper intermediate shaft to the lower intermediate shaft, at the midpoint connection. Collapse the lower shaft. Discard original bolt.
^ Use a new pinch bolt.





2. Remove the bolt securing the upper intermediate shaft to the steering column assembly. Remove the intermediate shaft from inside the vehicle. Discard the original bolt.

Installation





1. To install, reverse the removal procedure.