Cruise Control Servo Cable: Service and Repair

REMOVAL

NOTE: 5.4L 2 Valve Triton V8 shown; others are similar.







1. Remove the screws and the accelerator control splash shield.







2. Disconnect the speed control cable from the throttle nail head.
1 Open the throttle valve.
2 Slide the throttle cable to disconnect from the throttle cam nail head.
3 Squeeze the speed control cable tabs and remove from the throttle cable bracket.

3. Remove the speed control cable from the retaining clips.







4. Depress the locking tab and rotate the speed control cable cap to remove.







5. Remove the speed control cable.
1 Gently push the retaining spring.
2 Disconnect the speed control cable slug from the speed control servo pulley.

INSTALLATION
1. To install, reverse the removal procedure.

NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.