Ignition Lock Cylinder - Non Functional

IGNITION LOCK CYLINDER - NON FUNCTIONAL

REMOVAL
1. Disconnect the battery ground cable(s) to allow the depletion of the restraint system backup power supply.
2. Remove the steering wheel.







3. Twist off the cap from the ignition switch lock cylinder.







4. Remove the ignition switch lock cylinder.
- Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
- Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
- Remove and discard the ignition switch lock cylinder and drill shavings from the steering column.







5. CAUTION: Carefully note the position of the steering column lock gear, bearing and retainer prior to removal.

Remove the bearing retainer.







6. Remove the bearing and the gear.
- Thoroughly clean all drill shavings from the steering column and inspect it for damage.

INSTALLATION

1. NOTE: Use a new ignition switch lock cylinder.

To install, reverse the removal procedure.
Verify ignition switch lock cylinder operation.