Rear

Wheel Studs

Special Tool(s):

Special Tool(s)

Removal
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. On vehicles equipped with dual rear wheels, go to Step 7.
4. Remove the disc brake caliper and rotor.
5. Remove the rear wheel hub assembly.





6. Using a suitable press, remove the wheel bolt from the wheel hub and discard.





7. NOTE: For vehicles equipped with dual rear wheels, use the C-Frame and Screw to remove the wheel bolt on the vehicle.

Remove the wheel bolt from the wheel hub and discard.

Installation





1. Using a suitable press, install the new wheel bolt aligning the serrations in the wheel hub flange made by the original wheel bolt.





2. On vehicles with dual rear wheels, install the new wheel bolt aligning the serrations in the wheel hub flange made by the original wheel bolt.
- Place four flatwashers over the outside end of the wheel bolt and thread a standard wheel nut with the flat side against the washers.
- Tighten the wheel nut until the wheel bolt head seats against the back side of the hub flange.





3. Remove the wheel nut and flatwashers.
4. On vehicles with dual rear wheels, go to Step 7.
5. Install the rear wheel hub assembly.
6. Install the disc brake caliper and rotor.
7. Install the wheel and tire assembly.
8. Lower the vehicle.