Transmission Position Sensor/Switch: Adjustments

Transmission Range (TR) Sensor Adjustment





Special Tool(s)

CAUTION: Do not pry on the swivel tube to disconnect the transmission shift linkage.

NOTE: Manual shift lever must be in the NEUTRAL position.

1. With the vehicle in NEUTRAL, position it on a hoist.





2. Disconnect the digital TR electrical connector.





3. Disconnect the manual lever shift control cable.





4. Remove the manual control lever.
1. Remove the manual control lever nut.
2. Remove the manual control lever.





5. Loosen but do not remove the digital TR sensor bolts.





6. NOTE: The manual lever must be in the NEUTRAL position.

Using the special tool, align the digital TR sensor slots. The tool is designed to fit snug.





7. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.

Using the special tool, align the digital TR sensor and tighten the screws in an alternating sequence.





8. Install the manual control lever.
1. Position the manual control lever.
2. Install a new manual lever shaft outer nut.





9. With the manual lever in overdrive, connect the shift lever control cable.





10. Install the digital TR sensor electrical connector.