Exterior Mirror Cover - Integral Turn Signal

EXTERIOR MIRROR COVER - INTEGRAL TURN SIGNAL

Removal and Installation

NOTE: Part of the exterior mirror glass not shown for clarity.







1. NOTE: The small overlap ledge between the case front and the case rear can be used to prevent the clip from returning to the clipped position.

Tilt the exterior mirror glass away from each of the four corners one at a time, and insert a flat-blade screwdriver into the clip slot and release the clip while exerting finger pressure on the exterior mirror cover.

2. Remove the exterior mirror cover.
- Disconnect the turn signal module electrical connector.

3. To install, reverse the removal procedure.