Seat Belt Systems: Service and Repair

BELT MINDER DEACTIVATING/ACTIVATING

Preparation
1. Before deactivating/activating the belt minder, set the parking brake.
2. Place the gearshift in the P (Park) position.
3. Place the ignition switch in the OFF position.
4. Close all the vehicle doors.
5. Unbuckle the driver safety belt
6. Place the parklamps/headlamps switch in the OFF position.

Deactivating/Activating
1. Turn the ignition switch to the RUN position. (Do not start the engine).
2. Wait until the safety belt warning lamp turns off (approximately 1 minute).

3. NOTE: Step 3 must be completed within 60 seconds after the safety belt warning lamp turns off.

Buckle then unbuckle the safety belt 9 times, ending with the safety belt unbuckled.
- After step 3 is complete, the safety belt warning lamp will be turned on for 3 seconds.
- If step 4 does not occur within 10 seconds at the end of step 3, the beltminder will automatically exit programming made without changing its enable status.

4. Within 10 seconds of the lamp turning on, buckle then unbuckle the safety belt.
- This will disable the beltminder feature if it is currently enabled. As confirmation, the safety belt warning lamp will flash 4 times per second for 3 seconds.
- This will enable the beltminder feature if it is currently disabled. As confirmation, the safety belt warning lamp will flash 4 times per second for 3 seconds.