Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION (CKP) SENSOR







Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the accessory drive belt.







4. Loosen the A/C compressor bolts enough to slide the A/C compressor down 25 mm (1 in), to allow access to the CKP sensor.
5. Disconnect the CKP sensor electrical connector.
6. Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).

7. To install, reverse the removal procedure.