Initial Inspection and Diagnostic Overview
Inspection and VerificationNOTE: If a new ABS module is installed, it must be configured.
1. Verify the customer concern.
2. Verify the stoplamps operate correctly by applying and releasing the brake pedal. If the stoplamps operate correctly, proceed to the next step.
3. Verify that the PRNDL operates correctly on the instrument cluster. If the PRNDL operates correctly, proceed to the next step.
4. Visually inspect for obvious signs of mechanical or electrical damage.
Visual Inspection Chart
5. If the concern remains after the inspection, connect the diagnostic tool to the data link connector (DLC) located beneath the instrument panel, and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle: check that the program card is correctly installed.
^ check the connection of the data link connector to the vehicle.
^ check that the ignition switch is in the RUN position.
6. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
7. Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
^ CAN or ISO circuit fault; all electronic control units no response/not equipped, refer to Information Bus.
^ No response/not equipped for the ABS module, GO to Pinpoint Test A. Test A: No Communication With the Anti-Lock Brake System (ABS) Module
^ System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out the self-test diagnostics for the ABS module.
8. If the DTCs retrieved are related to the concern, go to the Anti-Lock Brake System (ABS) Module Diagnostic Trouble Code (DTC) Index. Anti-Lock Brake System (ABS) Module Diagnostic Trouble Code (DTC) Index
9. If no DTCs related to the concern are retrieved, GO to Symptom Chart. Symptom Chart)