Front Seat - Captain's Chair and 40 Percent
FRONT SEAT - CAPTAIN'S CHAIR AND 40 PERCENTRemoval and Installation
NOTE:
- New retaining bolts must be installed, do not reuse the bolts that were removed. The retaining stud(s) and nut(s) can be reused.
- Driver side shown, passenger side similar.
- Power seat without heat control shown, power seat with heat control similar.
All seats
1. NOTE: Passenger front inboard retainer cover shown, driver cover similar.
Remove the front inboard retainer cover.
2. NOTE: Passenger rear inboard retainer cover shown, driver similar.
Remove the rear inboard retainer cover.
3. Move the seat to its forward most position.
Power seats
4. NOTE: Passenger rear outboard retainer cover shown, driver cover similar.
Remove the rear outboard retainer cover.
5. Remove the front seat.
1 Remove and discard the three front seat riser support-to-floor retaining bolts.
2 Disconnect the safety belt buckle electrical connector (driver only).
3 Disconnect the seat switch electrical connector.
4 Remove the front seat riser support-to-floor pan retaining nut.
5 Remove the front seat.
Manual seats
6. Remove the front seat.
1 Remove and discard the two front seat riser support-to-floor retaining bolts.
2 Disconnect the safety belt buckle electrical connector (driver only).
3 Remove the two rear seat riser support-to-floor pan retaining nuts.
4 Remove the front seat.
All seats
7. CAUTION: When installing the seat, tighten the front mounting bolts, then the rear mounting bolt or nut(s).
To install, reverse the removal procedure.
- Make sure the safety belt webbing is not twisted prior to installation.
- Adjust the seat to the full forward and rearward positions a few times to assure safety belt and buckle accessibility.
8. Check the active restraint system for correct operation.