Ignition Switch

Ignition Switch
Removal and Installation
1. Depower the Supplemental Restraint System (SRS).





2. CAUTION: Use care when removing the instrument panel steering column cover or damage to the cover locating tab may occur.

Remove the instrument panel steering column cover.





3. If equipped, twist the tilt wheel handle and remove it.





4. Remove the lower steering column shroud.
1 Remove the screws.
2 Separate and remove the lower steering column shroud from the upper shroud and remove the lower.





5. Disconnect the ignition switch electrical connector.





6. Remove the ignition switch screws and remove the switch.
7. To install, reverse the removal procedure.