Rear Seat - SuperCab

REAR SEAT - SUPERCAB

Removal and Installation

NOTE: New retaining bolts must be installed, do not reuse the bolts that were removed. Retaining studs and nuts can be reused.

1. Remove the seat mounting retainer covers.







2. From the bottom of the seat backrest, push the seat backrest upward, then pull the bottom outward and remove from vehicle.







3. Position the seat cushions back, then remove and discard the retaining bolts.







4. Remove and discard the retaining bolt.







5. Remove and discard the retaining bolt and remove the retaining nut.







6. Remove the retaining nut.
7. To install, reverse the removal procedure.
8. Check the active restraint system for correct operation.
- Make sure the safety belt webbing is not twisted prior to installation.