Attachment III - Technical Information

MODULE RECALIBRATION

NOTE:
This recalibration, using WDS software Version B40.7 or higher, or B41.1 or higher, will update the PCM, TCM and FICM. This new calibration is not included in the B41 CD. Calibration files may also be obtained at the website.

1. Connect a battery charger to the vehicle.

2. Using Worldwide Diagnostic System (WDS), recalibrate the modules to the latest level calibration.

3. VERIFY THE WDS IS LOADED WITH SOFTWARE VERSION B40.7 OR HIGHER, ORB41.1 OR HIGHER.

4. Select Module Configuration Programming (MCP) and follow the WDS display instructions.

^ If unable to recalibrate the modules:

- module replacement will not be covered under this program.

- prior to disconnecting the WDS from the vehicle and closing the session, call the Special Service Support Center.

5. Perform a self-test to verify there are no further concerns.

AUTHORIZED MODIFICATIONS LABEL INSTALLATION





1. Obtain and prepare the Authorized Modifications Label. Describe the modification performed, and enter your P&A Code, date of repair and the program type and program number. See Figure 1.

PROOF OF CORRECTION CERTIFICATE





1. Provide the owners of vehicles registered in California and Massachusetts with a completed "Vehicle Emissions Recall - Proof of Correction" certificate. See Figure 2.