Basic Circuit Checks

BASIC CIRCUIT CHECKS

Description
Basic circuit checks help to minimize pinpoint test steps by providing a procedure to diagnose harness faults associated with the electronic engine control (EEC) system. The following techniques provide helpful reminders for diagnosing open circuits (continuity), shorts to ground, and shorts to voltage.

NOTE
- The suspect circuit must be isolated before testing.
- When disconnecting any harness connector, always inspect for damaged or pushed-out pins, corrosion, and loose wires. Repair as necessary.
- The digital multimeter (DMM) must be set to the correct scale.
- The techniques do no apply in all situations; therefore, it is necessary to carry out each pinpoint test step accurately and completely.
- General resistance and voltage values are specified. Always use the pinpoint test values if they differ.
- Always turn the key to the OFF position unless directed otherwise by the pinpoint test.

Each of the following procedures requires the powertrain control module (PCM) and component to be disconnected to isolate the harness.

Open Circuit (Continuity)
Disconnect the appropriate PCM harness. Measure the harness resistance between the suspect circuit at the harness connector and the appropriate PCM harness pin. The resistance must be less than 5 ohms.

Shorts to Ground
Measure the harness resistance between the suspect circuit at the harness connector and a reliable ground (B-, chassis or power ground [PWR GND] at the PCM harness). The resistance must be greater than 10,000 ohms.

Shorts to Power
Key ON to power up the circuit. Measure the voltage between the suspect circuit at the harness connector and a reliable ground. The voltage must be less than 0.2 volt.