Fuel Conditioning Module
FUEL CONDITIONING MODULEAft-of-Axle Fuel Tank - Diesel:
Midship Fuel Tank - Diesel (Part 1):
Midship Fuel Tank - Diesel (Part 2):
Exploded View
Removal and Installation
1. WARNING: Smoking and open flame of any type must not be present when working near fuel or fuel vapor. Failure to follow these instructions may result in personal injury.
With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Open the fuel/water separator drain valve to release the fuel pressure.
- To install, tighten to 1 Nm (9 lb-in).
4. Disconnect the fuel conditioning module electrical connectors.
5. NOTE: Rear fuel tubes shown, front fuel tubes similar.
Disconnect the 4 fuel tube push connect fittings.
6. Disconnect the wiring push pin. Remove the mounting bolts and the fuel conditioning module.
- To install, tighten to 17 Nm (13 lb-ft).
7. To install, reverse the removal procedure.