Liftgate Latch

LIFTGATE LATCH

Removal and Installation
1. Remove the liftgate trim panel.
2. Disconnect the liftgate ajar switch electrical connector.







3. Disconnect the liftgate latch actuating rod.
1 Open the clip.
2 Disconnect the actuating rod.







4. Remove and discard the 3 liftgate latch bolts.
- To install, tighten to:
- 8 Nm (71 lb-in)(vehicles built through 10/2005)
- 12 Nm (9 lb-ft)(vehicles built after 10/2005)

5. Remove the liftgate latch.
6. To install, reverse the removal procedure.
- Lubricate the liftgate latch to striker surfaces with Krytox grease after installation.