Computers and Control Systems: Tools and Equipment

DIAGNOSTIC TOOLS AND EQUIPMENT

Below is an equipment list with corresponding part numbers:

REQUIRED SAFETY EQUIPMENT:

The Buffer Zone:

- Rubber insulating gloves

NOTE: The rubber insulating gloves are to be worn while working on high-voltage components or high-voltage cables. They must be inspected before use and must be worn in conjunction with the leather outer glove. Any hole in the rubber glove is a potential entry point for high voltage. To inspect the glove roll it up from the open end until the lower portion of the glove begins to balloon from the resulting pressure. If the glove leaks any air it must not be used.

- 4 safety cones

NOTE: The buffer zone is required only when working with the high-voltage components or cables. Position 4 orange safety cones around the corners of the vehicle to mark off a 1 meter (3 feet) perimeter around the vehicle.

- Safety face shield

NOTE: The safety face shield is to be worn while working on high-voltage components or high-voltage cables.

REQUIRED EQUIPMENT:
- Rotunda Worldwide Diagnostic System (WDS), Vehicle Communication Module (VCM) with appropriate adapters or equivalent diagnostic tool with functionality described under Diagnostic Tool Setup and Functionality.
- Evaporative Emission System Tester 310-F007 (134-00056) or equivalent.

RECOMMENDED EQUIPMENT:
- Rotunda Vacuum/Pressure Tester 164-R0253 or equivalent. Range 0-101.3 kPa (0-30 in-Hg.) Resolution 3.4 kPa (1 in-Hg.)
- Rotunda Vacuum Tester 014-R1054 or equivalent. Range 0-101.3 kPa (0-30 in-Hg.)
- Rotunda 73III Automotive Meter 105-R0057 or equivalent. Input impedance 10 Megaohm minimum.
- Spark Tester D81P-6666-A (303-D037) or equivalent.
- Non-powered test lamp.

OPTIONAL EQUIPMENT:
- Rotunda Fuel (Gasoline) pressure test kit 134-R0087 or equivalent. (Use tool manufacturer's instructions.)