Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear:

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.





2. CAUTION: Care must be taken during the removal of the plug to prevent damage. If the plug is damaged, a new sensor may need to be installed, even though the sensor is functional in all other aspects.

Remove the grommet from the body.
^ When removing the body plug, rotate the plug into a position which allows the use of a small screwdriver to release the tabs on the underside of the body plug. These 2 tabs are located at right angles to the sensor wire.
3. Disconnect the rear wheel speed sensor wire connector.
4. Remove the rear wheel speed sensor wire from the retainer.
5. Remove the 3 rear wheel speed sensor wire bolts.
^ To install, tighten to 9 Nm (80 inch lbs.).

6. NOTE: Clean off any debris that may have collected around the sensor before removal.

Remove the rear wheel speed sensor bolt from the wheel knuckle.
^ To install, tighten to 9 Nm (80 inch lbs.).
7. Remove the rear wheel speed sensor.

8. NOTE: Thoroughly clean the mounting surface.

To install, reverse the removal procedure.