Transfer Case - Automatic Transaxle
Transfer Case - Automatic TransaxleMaterial:
1. CAUTION: A new transfer case inner halfshaft seal must be installed whenever the intermediate shaft or transfer case is removed from the vehicle.
NOTE: If necessary, install a new RH differential fluid seal.
Position the transfer case to the transaxle.
2. Install the transfer case-to-engine brace.
3. Connect the transfer case vent hose.
4. Install the 4 transfer case-to-transaxle bolts.
^ Tighten to 45 Nm (33 ft. lbs.).
5. Install the transfer case heat shield and the 3 transfer case heat shield bolts.
^ Tighten to 14 Nm (10 ft. lbs.).
6. Install the generator.
7. Install the crossmember brace and the 4 bolts.
^ Tighten the bolts to 40 Nm (30 ft. lbs.).
8. Install the driveshaft.
9. Install the front RH intermediate shaft.
10. Install the exhaust as required.
11. Fill the transfer case.
12. Check the transaxle fluid level.