Ignition Cable: Service and Repair

SPARK PLUG WIRES







Exploded View

Remover, Spark Plug Wire:

Special Tool(s)

Removal and Installation
1. Disconnect the battery ground cable.

2. CAUTION: It is important to twist the spark plug wire boot while pulling upward to avoid possible damage to the spark plug wire.

NOTE: Spark plug wires must be connected to the correct ignition coil terminal. Mark the spark plug wires for installation reference.

Squeeze the locking tabs and twist while pulling upward to disconnect the 6 spark plug wires from the ignition coil.

3. Detach the spark plug wires from the spark plug wire retainers.







4. CAUTION: It is important to twist the spark plug wire boot while pulling upward to avoid damage to the spark plug wire.

NOTE: Spark plug wires must be connected to the correct spark plug. Mark the spark plug wires for installation reference.

With a twisting motion, use the special tool to pull the spark plug wires from the spark plugs.

5. NOTE: Apply silicone dielectric compound to the inside of the spark plug wire boots.

To install, reverse the removal procedure.