Door Lock Cylinder: Service and Repair

DOOR LOCK CYLINDER

Removal and Installation

All doors

NOTE:
- When a new lock cylinder is installed, the door lock cylinder and ignition lock cylinder should be installed as a set. This eliminates carrying an extra key which fits only one lock. If a new key is used, the new key code number is stamped on a metal tag attached to the key.
- Individual lock cylinders are repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.

1. If equipped, remove the door trim panel.

Side Door/Front Door







2. Disconnect the lock cylinder actuating rod.







3. Remove the retainer and the door lock cylinder.

Rear Door







4. Remove the 4 license plate housing screws.
5. Position the housing away from the door.







6. Disconnect the lock cylinder actuating rod and the door latch actuating cable.







7. Remove the retainer and the door lock cylinder.

Sliding Door
8. If equipped, remove the speaker.
- Remove the 4 screws.
- Disconnect the speaker electrical connector.







9. Disconnect the lock cylinder actuating rod.







10. Remove the retainer and the lock cylinder.

All Doors
11. To install, reverse the removal procedure.