Accelerator Pedal: Service and Repair

ACCELERATOR PEDAL







Removal and Installation

CAUTION: The accelerator pedal and position sensor assembly is a non-adjustable, calibrated unit and must be handled with care.

1. Disconnect the battery ground cable.

2. NOTE: The red clip must be pulled out before disconnecting the electrical connector.

Disconnect the accelerator pedal position sensor electrical connector.

3. Remove the 2 bolts and slide the accelerator pedal and position sensor assembly up and off the anchor bolt.
- To install, tighten to 25 Nm (18 lb-ft).

4. To install, reverse the removal procedure.