Disc Removal and Installation, Rear
Brake DiscRemoval and Installation
1. Remove the 2 stone shield nuts and the stone shield.
^ To install, tighten to 40 Nm (30 ft. lbs).
2. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the 2 caliper anchor plate stud bolts and position the caliper and anchor plate assembly aside.
^ Support the caliper and anchor plate assembly using mechanic's wire.
^ To install, tighten to 175 Nm (129 ft. lbs).
3. Index-mark the brake disc.
4. Remove the brake disc.
5. To install, reverse the removal procedure.