Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)

Removal and Installation

1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.

Turn the ignition switch to the OFF position.







2. Remove the retainers and the air deflector.







3. Remove the power steering reservoir bracket retainers.







4. Remove the power steering fluid indicator and retainers. Remove the power steering reservoir bracket. Install the power steering indicator and position aside.







5. Disconnect the coolant hoses from the air cleaner outlet pipe.







6. NOTE: Air cleaner side shown, engine side similar.

Loosen the clamps and remove the air cleaner outlet pipe.







7. Unlatch and disconnect the powertrain control module (PCM) electrical connectors.







8. Remove the bolt and PCM.
- Tighten to 9 Nm (80 lb-in).

9. To install, reverse the removal procedure.