Oil Pump: Service and Repair

Oil Pump

Material:

Removal
1. Remove the timing drive components.
2. Remove the oil pan.
3. Remove the 3 bolts and the oil pump.





Installation

1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These may cause scratches and gouges resulting in leak paths. Use a plastic scraper to clean the sealing surfaces.

Clean the sealing surfaces with metal surface prep. Follow the directions on the packaging. Inspect the mating surfaces.
2. Install the oil pump and tighten the 3 bolts in the sequence shown.
^ Tighten to 10 Nm (89 inch lbs).





3. Install the oil pan.
4. Install the timing drive components.