ABS Sensor Block: Service and Repair

Stability Control Sensor Cluster

Stability Control Sensor Cluster:

Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Disconnect the stability control sensor cluster electrical connector.
3. Remove the 2 stability control sensor cluster bolts.
^ To install, tighten to 6 Nm (53 inch lbs).
4. Remove the stability control sensor cluster.
5. To install, reverse the removal procedure.
^ Calibrate the anti-lock brake system (ABS) module. Follow the scan tool directions. Clear the DTCs. Carry out the self-test with the brakes not applied.