Shifter A/T: Service and Repair

Selector Lever

Selector Lever:

Removal and Installation
1. Disconnect the battery. For additional information, refer to Battery.
2. If equipped with tilt column, position the steering wheel in the full down position.
3. Pull the headlamp knob to the ON position.
4. Insert a small screwdriver onto the clip and pull the knob outward.





5. Remove the headlamp switch bezel by turning it counterclockwise.





6. Remove the audio unit. For additional information, refer to Radio, Stereo, and Compact Disc.
7. Remove the 2 instrument cluster finish panel screws.





8. CAUTION: To avoid damage to the instrument cluster finish, pull the panel forward just enough to access electrical connectors before completely removing the panel.

Remove the instrument cluster finish panel.
^ Disconnect the electrical connectors.





9. Remove the ignition switch lock cylinder.
1 Position the lock cylinder to RUN.
2 Using a suitable tool, push upward on the cylinder release tab through the hole in the lower shroud while pulling the cylinder outward.





10. Remove the upper steering column shroud.





11. Remove the transmission range selector lever. Disconnect the electrical connector.





12. NOTE: Install a new transmission range selector lever pin whenever it is removed.

To install, reverse the removal procedure.