Seat Backrest - Rear, Bench

SEAT BACKREST - REAR, BENCH

Removal and Installation

1. Remove the rear bench seat assembly.

2. Remove the RH detachable safety belt anchor buckle end, if so equipped.
1. Release the cushion trim cover J-clips.







2. Remove the detachable safety belt anchor buckle end bolt.
- To install, tighten to 40 Nm (30 lb-ft).

3. Remove the detachable safety belt anchor buckle end.







3. Release the J-clip and remove the pin-type retainer at the RH rear of the seat.







4. Remove the LH detachable safety belt anchor buckle end, if so equipped.
1. Release the cushion trim cover J-clips.
2. Remove the detachable safety belt anchor buckle end bolt.
- To install, tighten to 40 Nm (30 lb-ft).

3. Remove the detachable safety belt anchor buckle end.

5. Release the J-clip and remove the pin-type retainer at the LH rear of the seat.







6. Remove the 4 seat back frame-to-seat cushion frame bolts (2 shown) and remove the seat back.
- To install, tighten to 25 Nm (18 lb-ft).

7. To install, reverse the removal procedure.
- Make sure the safety belts and buckles are accessible to the occupants after installation.